Reminders for dealing with down corn
When down corn disrupts harvest season, the potential for yield loss should never be underestimated.
“It’s not uncommon to see 10 to 20 bushels/acre of yield loss in down corn, and in severe cases, losses can accelerate up to 50 bushels/acre,” says Fenton, Iowa farmer and Dragotec President, Denny Bollig.
“Down corn can happen so quickly. The amount of loss will depend on the type of growing season and having the right harvest equipment to get under the stalk, stand it up and bring it in,” he says. “That’s why it’s so important for growers to have a corn head that can handle a multitude of field conditions.”
Root Problems Increase Risk
Although severe storms and high winds contribute to stalk lodging and down corn, crop conditions throughout the planting and growing season can also impact the likelihood a down corn event will occur.
“Saturated soils early in the season can have long-term effects on root development,” says Bollig. “This year, excessive rainfall in parts of the Corn Belt resulted in areas of very shallow rooted corn. Wet conditions and compaction from heavy equipment weaken plant standability and increase susceptibility to wind damage.”
Deterioration of stalk material from plant diseases, like corn root rot, or infestation from insects, such as stalk borers, can also cause premature plant break-off or lodging.
Because these conditions can change so rapidly across the field, it’s a good idea to scout fields for problem areas and check the condition of stalks and ears when beginning harvest.
“As plant material starts to dry out and break down, yield loss potential mounts quickly,” says retired Iowa State University Extension ag engineer Mark Hanna.
“Harvest problem areas first when field conditions are better and before ears in close proximity to the ground have an opportunity for further deterioration,” Hanna says. “An exception might be made to harvest an area with particularly weak stalk strength that is still standing if the odds of lodging from weather seem high.”
Make The Right Adjustments
Reducing corn yield loss at harvest in down or lodged corn takes both the right machinery and specific attention to how it must be adjusted in order to pick up and process corn plants hugging the ground. Hanna recommends the following steps to ensure your corn head and combine are ready for a field with down corn:
Set deck plates carefully. If a producer is running a corn head with hydraulic or bolted deck plates, make sure they are “only slightly wider than cornstalks” in order to cut down on stalks breaking off before ears can be removed. If running a Drago corn head with automatic self-adjusting deck plates, variable stalk sizes are accounted for in each individual row.
Get low, but not too low. “Operate the head as low as practical without picking up rocks or significant amounts of soil,” Hanna says. Adjust how you drive. Moving against the grain of the stalks of down corn can reduce harvest losses. “Evaluate losses, though, before spending large amounts of time dead-heading through the field,” he adds.
Slow everything down. Harvesting slower than normal in down corn is typical. Make sure everything is adjusted to account for the necessary slowdown. “If harvest speeds are significantly reduced, the amount of material going through the combine is reduced. Fan speed may need to be reduced to avoid blowing kernels out of the combine and rotor speed may also need to slow to maintain grain quality. Check kernel losses behind the combine and grain quality to fine tune cleaning and threshing adjustments,” says Hanna.
Once the machinery has been adjusted, Hanna adds it’s important to remember that harvesting down or lodged corn takes longer than standing corn. “Down corn is never a problem producers want to deal with during the urgency of harvest, but having a corn head that can handle downed areas from both directions in the field means big cost and time savings,” Bollig says.
“Drago is unmatched in picking up plants leaning away from the row unit. Our aggressive overlapping gathering chains reach down, get completely behind the stalk, bring it in with less trash and get more ears to the combine.”